This post was last modified: 2014-02-11, 08:41 by ferraro.

Gunther:
Got a sequence of CR2 files done adjusting manually the speed to be tested on LRTL, 3 changes during the way.
Trying to unload the files an alarm says:

Could not create directory.. and gives the address where the files should be

I first loaded on LR 5 and saved the metadata but the problem persists. I am using the trial LRTL 3.2.1 which, by the way, only allows me to put the files on the system disk.....the original CR2's also must be there because it does not recognise any other drive. No way it allows to see any other drive...
Uninstalled and installed again, put 400 cr2 images on the SD card and tried to import. This time it claims that only supports 400 images, the very same number I am telling to import. Left 200, the same. The ebook does not give me a clue either.
What am I doing wrong? I need to be it absolutely works for me before buying a license.
Thanks

Imac Quad 3.4, 2GB graphics, 16GB ram, latest IOS

This post was last modified: 2014-02-11, 10:47 by Gunther.

I think you are doing something wrong.
First: don't use "import" in LRTimelapse if the files are already on the hard drive, just open the sequence in the folder tree.
Second: external drives certainly are supported, on mac os you can find them under "volumes"! See faq: http://forum.lrtimelapse.com/Thread-mac-...nal-drives

I think you are doing something wrong.
First: don't use "import" in LRTimelapse if the files are already on the hard drive, just open the sequence in the folder tree.
Second: external drives certainly are supported, on mac os you can find them under "volumes"! See faq: http://forum.lrtimelapse.com/Thread-mac-...nal-drives

Yes I was, found volumes and the files are load, will now go no
thanks