• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Interval Scheduling

Offline
#1 Graphections
Is it possible to schedule when the intervelometer starts and stops?
Lets say you only want it to shoot from 8am - 5pm everyday?
Also has this been tested with a wall socket for long term power?
Offline
#2 Gunther
Currently this is not possible because the Arduino does not have a real time clock. Wall powering via the USB port or 12v is no problem.

sent mobile via tapatalk...
Subscribe to: LRTimelapse Newsletter, Youtube Channel, Instagram, Facebook.
Offline
#3 Graphections
(2017-03-18, 19:24)gwegner Wrote: Currently this is not possible because the Arduino does not have a real time clock. Wahl Portierung via the USB port or 12v is no problem.

sent mobile via tapatalk...

What if there was a simple 24 timer function added? you could set the Intervalometer to run for 12 hours, then stop for 12 and then start again for another - or 8 and 16 and so on. Once you power off the Unit it resets
So long as you are there at the time you want to start the time-lapse

What is Wahl Portierung?
Offline
#4 Gunther
Sorry corrected the auto correction.
Sure that would be possible, with some changes to the code. It's open source.

sent mobile via tapatalk...
Subscribe to: LRTimelapse Newsletter, Youtube Channel, Instagram, Facebook.
Offline
#5 Graphections
Thanks I will look into it and share the results.
On a side note, does LRT 4.7.5 not work with Windows Vista? I have a fresh Vista 64 bit install with Service Pack 2 and LRT 4.7.5 just flashes the start screen then disappears and doesn't start.
Offline
#6 Gunther
Normally it should work, but I don't know. Vista is outdated, Microsoft support ends next month. It shouldn't be used anymore.

sent mobile via tapatalk...
Subscribe to: LRTimelapse Newsletter, Youtube Channel, Instagram, Facebook.

...also check out: