LRTimelapse Forum

Use dji dng raw file cannot transfer WB Temp Metadata

Click on the leftmost icon above the table to see all columns. By default LRTimelapse will only show columns with values which are keyframed (have changing values).

also have problem of transfer WB Temp

There was a problem with DJI DNG files, it was fixed in 5.0.9. But you need to start over with that sequence. Use "Metadata/Clear Metadata" to get a clean start, remove the sequence from Lightroom. Then start over and it should work.

i use 5.0.9 already before, Clear Metadata and get a clean start, still have this issue (i use dji new product Mavic 2 pro to shot this DNG files)

exact same problem with mavic 2 pro DNG files. WB values wouldnt transfer, tried clearing metadata, reinitialize, reinstall etc etc. WB value do show up for split second when reload a edited metadata

And you are sure that you are using LRTimelapse 5.0.9 ? It won't work with older versions.

There is always the way to manually set the Whitebalance Treatment to "Absolute" via "Metadata/Set Whitebalance Treatment" in LRTimelapse. That's what should happen automatically, but you can force it also for those files if the detection does not work for some reasons. Please try.

WB is still stuck at 5850 after choosing absolute, and that is after cleared and reinitialized metadata

uploading 3 image for you to check, try and adjust the WB annd see
https://drive.google.com/open?id=1UOHrx_...n8ETEQee5F