2017-05-27, 07:48
Hi,
I just installed LRTimelapse 4.7.6 to try it out. I followed the video tutorial and ran into a problem.
I have a short sequence of 70 images from Canon 7D Mark II (cr2).
The images loaded into LRTimelapse and I can scrub through the video at the top left. It is a pretty consistent exposure and so I only used 2 keyframes, one at the start and one at the end. The blue and yellow lines are straight (I assume it is because the lighting was the same throughout the sequence). The blue line is below the yellow line. I then hit the Save XMP button and got this error message: "ERROR writing: 20170525-MG_0088-1.xmp" for all the images (images are numbered -1, -2 etc). I clicked on the Drag to Lightroom button to see if it works and I can import the images; but, there are no keyframes.
Are my images named wrong? Or is it the number of keyframes I added? Or is it something else?
Thanks.
I just installed LRTimelapse 4.7.6 to try it out. I followed the video tutorial and ran into a problem.
I have a short sequence of 70 images from Canon 7D Mark II (cr2).
The images loaded into LRTimelapse and I can scrub through the video at the top left. It is a pretty consistent exposure and so I only used 2 keyframes, one at the start and one at the end. The blue and yellow lines are straight (I assume it is because the lighting was the same throughout the sequence). The blue line is below the yellow line. I then hit the Save XMP button and got this error message: "ERROR writing: 20170525-MG_0088-1.xmp" for all the images (images are numbered -1, -2 etc). I clicked on the Drag to Lightroom button to see if it works and I can import the images; but, there are no keyframes.
Are my images named wrong? Or is it the number of keyframes I added? Or is it something else?
Thanks.