+- LRTimelapse Forum (https://forum.lrtimelapse.com)
+-- Forum: Archive (https://forum.lrtimelapse.com/Forum-archive)
+--- Forum: LRT5 - General Questions (https://forum.lrtimelapse.com/Forum-lrt5-general-questions)
+--- Thread: Cannot drag sequence into Lightroom-it springs right back to original position (/Thread-cannot-drag-sequence-into-lightroom-it-springs-right-back-to-original-position)
Cannot drag sequence into Lightroom-it springs right back to original position - Dale Davis - 2020-08-08
I shot a day to night sequence, used manual key frames (6), could not drag into Lightroom. Why.
RE: Cannot drag sequence into Lightroom-it springs right back to original position - Gunther - 2020-08-08
Try restarting LRTimelapse and Lightroom. Then make sure that Lightroom is in Library (Grid) mode.
Now try again.
RE: Cannot drag sequence into Lightroom-it springs right back to original position - circlingkailas - 2020-08-26
Unfortunately, I seem to have a similar problem now. I follow the workflow, but when I drag into Lightroom, it looks like the files are loaded but everything gets greyed out and the Import button disappears. Not sure what is going on, but I will say that this was a sequence of images that I trashed from my hard-drive and reloaded. Any ideas? Thanks
RE: Cannot drag sequence into Lightroom-it springs right back to original position - Gunther - 2020-08-26
Most likely those files are already present in the Lightroom catalog then they get detected as "duplicates" and not imported again.
You need to remove the files from the Lightroom catalogue first, then you can do the import process.