Error Shutter speed - Printable Version +- LRTimelapse Forum (https://forum.lrtimelapse.com) +-- Forum: Archive (https://forum.lrtimelapse.com/Forum-archive) +--- Forum: LRT3 - Archive (https://forum.lrtimelapse.com/Forum-lrt3-archive) +--- Thread: Error Shutter speed (/Thread-error-shutter-speed) |
Error Shutter speed - xandrobc - 2014-07-01 Good Afternoon: If there is a failure in some intermediate exposure photographs (over 2 steps), you can fix that by compensating the exposure with Camera Raw and then work with LRTIMELAPSE sequence? For example, the first shots with shutter speed 1/40, then 17 shots with error (nr. 67 to 83) and then turns to the camera set to ok. As picture attached. This sequence has a solution? Best, RE: Error Shutter speed - Gunther - 2014-07-01 Just use the holy grail workflow and the holy grail wizard to smoothen that out! RE: Error Shutter speed - xandrobc - 2014-07-02 I check the video tutorials and the book, but I do not get good results. :-( Attached file. RE: Error Shutter speed - Gunther - 2014-07-02 Sorry but you really messed up that one when shooting. You could try making a first export with that setup, then export with LRTExport and load the intermediary sequence (LRT_*) into LRTImelapse again and try the deflicker workflow on that. It's explained in the EBook as well. RE: Error Shutter speed - xandrobc - 2014-07-02 I do not think it's a problem of flicker. There was a problem with the diaphragm in the shooting. It closed at f6. I do not know why. The jump is very large. Throughout the sequence I worked at f8. |