Interval Scheduling - Printable Version +- LRTimelapse Forum (https://forum.lrtimelapse.com) +-- Forum: LRTimelapse PRO Timer (https://forum.lrtimelapse.com/Forum-lrtimelapse-pro-timer) +--- Forum: LRT Pro Timer Free (English) (https://forum.lrtimelapse.com/Forum-lrt-pro-timer-free-english) +--- Thread: Interval Scheduling (/Thread-interval-scheduling) |
Interval Scheduling - Graphections - 2017-03-18 Is it possible to schedule when the intervelometer starts and stops? Lets say you only want it to shoot from 8am - 5pm everyday? Also has this been tested with a wall socket for long term power? RE: Interval Scheduling - Gunther - 2017-03-18 Currently this is not possible because the Arduino does not have a real time clock. Wall powering via the USB port or 12v is no problem. sent mobile via tapatalk... RE: Interval Scheduling - Graphections - 2017-03-18 (2017-03-18, 19:24)gwegner Wrote: Currently this is not possible because the Arduino does not have a real time clock. Wahl Portierung via the USB port or 12v is no problem. What if there was a simple 24 timer function added? you could set the Intervalometer to run for 12 hours, then stop for 12 and then start again for another - or 8 and 16 and so on. Once you power off the Unit it resets So long as you are there at the time you want to start the time-lapse What is Wahl Portierung? RE: Interval Scheduling - Gunther - 2017-03-18 Sorry corrected the auto correction. Sure that would be possible, with some changes to the code. It's open source. sent mobile via tapatalk... RE: Interval Scheduling - Graphections - 2017-03-19 Thanks I will look into it and share the results. On a side note, does LRT 4.7.5 not work with Windows Vista? I have a fresh Vista 64 bit install with Service Pack 2 and LRT 4.7.5 just flashes the start screen then disappears and doesn't start. RE: Interval Scheduling - Gunther - 2017-03-19 Normally it should work, but I don't know. Vista is outdated, Microsoft support ends next month. It shouldn't be used anymore. sent mobile via tapatalk... |