Posts: 17
Threads: 5
Joined: Jan 2013
Posts: 17
Threads: 5
Joined: Jan 2013
THEN add the ability to move the curve up and down by clicking on it and dragging...as shown by white cursor arrow in attached image. This would change all of the appropriate settings in the table. So if the final brightness curve showed an unexpected bump in the middle of the sequence you could just click on the top of that bump on the curve and drag it down to even out the curve and then the values in the table would adjust resulting in smooth brightness throughout.
The clicking and dragging on the curve to make adjustments could work like Microsoft's Power Point curve adjustment where you get two points that extend out from the point you clicked on the curve allowing you to determine how much of the bends.