Posts: 3
Threads: 1
Joined: Feb 2022
Posts: 3
Threads: 1
Joined: Feb 2022
I bought a lrtimelapse pro3 a month or so back and despite the instructions didn't get round to upgrading the firmware (it was on 23) all seemed to be working fine.
i did notice a tiny bit of variation in the exif interval times between shots when i loaded them into lrtimelapse, perhaps 4.9 to 5.1 seconds (for a 5 second interval). I never had any variation in interval times with my previous cheap £15 intervalometer.
I've only shot a handful of sequences between 150 - 290 shots and they all worked fine. However, at the weekend i shot 2 timelapses back to back and at around the 200 image mark the timer started dropping frames see attached.
I've just updated the firmware to 28 and increased the release time from 200ms to 250ms - not sure why it would start dropping frames after 200 shots?
I've now shot a few test sequences of 220 frames and it's not dropped any, but there is still a little variation in time is this expected?
all sequences are on single shot, manual focus on a canon 200d.
any advice much appreciated
keith
i did notice a tiny bit of variation in the exif interval times between shots when i loaded them into lrtimelapse, perhaps 4.9 to 5.1 seconds (for a 5 second interval). I never had any variation in interval times with my previous cheap £15 intervalometer.
I've only shot a handful of sequences between 150 - 290 shots and they all worked fine. However, at the weekend i shot 2 timelapses back to back and at around the 200 image mark the timer started dropping frames see attached.
I've just updated the firmware to 28 and increased the release time from 200ms to 250ms - not sure why it would start dropping frames after 200 shots?
I've now shot a few test sequences of 220 frames and it's not dropped any, but there is still a little variation in time is this expected?
all sequences are on single shot, manual focus on a canon 200d.
any advice much appreciated
keith