2017-10-10, 23:20
I'm in Shanghai at the moment and have been looking for a rail and a motion controller. There are very few here, but I was shown a Vectorgear Motion Evo. It looks very similar to a Rhino gear mk1 rail and controller. The Rhino controllers are black, this one was silver with a wooden effect knob. I was wondering if they were the same thing, or if the Vectorgear is a Chinese copy? It looked pretty good quality and was much cheaper than sourcing a Rhinogear back home in the UK.
I'm not keen to get a Chinese copy - especially since it had the old software - I'd want to update to one where you could choose the interval etc, as seen on another thread here. I must say I am tempted though. I would be happy if it was a real Rhino bit of kit though.
Any thoughts?
My favorite solution for my needs is a Syrp at the moment, so I am considering that - but for the price I think the Vectorgear looks like a good solution, especially if it is the same as the Rhino and I can update the software.
I'm not keen to get a Chinese copy - especially since it had the old software - I'd want to update to one where you could choose the interval etc, as seen on another thread here. I must say I am tempted though. I would be happy if it was a real Rhino bit of kit though.
Any thoughts?
My favorite solution for my needs is a Syrp at the moment, so I am considering that - but for the price I think the Vectorgear looks like a good solution, especially if it is the same as the Rhino and I can update the software.