Posts: 33
Threads: 4
Joined: Jun 2013
Hallo zusammen,
ich wollte meinen TP-Link MR3040 V2 am Wochenende auf die neue Firmware updaten, damit die Zusammenarbeit mit der neuen Software DslrDB wieder funktioniert. Vorher hat alles zusammen funktioniert.
Allerdings konnte ich mich anmelden. Die Standard Username+Password wurde nicht akzeptiert. Leider kann ich mich nicht sicher erinnern, ob ich bei der Erstinstallation damals Username+Password geändert habe. Den Resetknopf am MR3040 habe ich schon probiert : keine Änderung.
Hat jemand eine Idee, wie ich vorgehen kann? Wie muss der Schalter am MR3040 stehen? Bleibt der beim Firmwareupdate auf AP?
Gruß Jürgen
ich wollte meinen TP-Link MR3040 V2 am Wochenende auf die neue Firmware updaten, damit die Zusammenarbeit mit der neuen Software DslrDB wieder funktioniert. Vorher hat alles zusammen funktioniert.
Allerdings konnte ich mich anmelden. Die Standard Username+Password wurde nicht akzeptiert. Leider kann ich mich nicht sicher erinnern, ob ich bei der Erstinstallation damals Username+Password geändert habe. Den Resetknopf am MR3040 habe ich schon probiert : keine Änderung.
Hat jemand eine Idee, wie ich vorgehen kann? Wie muss der Schalter am MR3040 stehen? Bleibt der beim Firmwareupdate auf AP?
Gruß Jürgen